Every job below is one we do ourselves across McAllen.
We design and build new decks from the footings up, sized to fit your yard and how you plan to use the space. Footings go below grade and get checked before we pour, because a deck is only as good as what's under it. You can go with pressure-treated pine, cedar, or a composite board like Trex if you want less upkeep.
Some yards call for more than a rectangle off the back door, think multi-level decks, built-in benches, or a deck that wraps around a pool. We draw it out and walk through the layout with you before any lumber shows up, so you know where the stairs land and how the railing lines run.
Soft boards, a railing with play in it, stairs that bounce, we get called out for all of it. We replace rotten joists instead of covering them up, and we check the ledger board attachment on every repair job because that's where most structural problems start.
Pine and cedar both need a sealer or a quality stain reapplied every one to two years out here, the UV is relentless and it breaks down finish faster than it would further north. We pressure wash first, let the wood dry out fully, then stain, because sealing over damp lumber just traps moisture underneath.
Composite boards don't rot and they don't need staining, which matters if you don't want a maintenance project every spring. They still expand and contract with heat, so hidden fastener spacing and trim have to be done right or the deck telegraphs every gap by August.
Code calls for a 36 inch minimum rail height on most residential decks and baluster spacing under 4 inches, and we build to that whether it's wood, cable, or aluminum. A loose post usually means it was toe-nailed instead of through-bolted, and we fix it that way instead of just tightening what's there.
Sometimes the frame underneath is solid and it's just the decking on top that's shot, cupped, splintered, or gray past saving. We pull the bad boards, match the spacing on what's left, and swap them out without tearing the whole structure apart.
A lot of McAllen homeowners want shade or a screen over part of the deck so mosquito season doesn't shut down the back yard. We frame covers and screen panels that tie into the existing deck structure instead of standing on their own separate posts.
Posts, beams, and joists are what actually hold the deck up, and they're the part nobody sees until something gives. We size lumber to span and load, not just to what looks right, and we check post footings for movement before building anything on top of them.
Pergolas, privacy screens, and built-in planters get added onto a new deck project or built onto a deck that's already there. They need to tie into the existing framing correctly so the whole structure moves together instead of pulling apart at the seam.
Four steps, and no surprises in any of them.
You tell us what you want doing, we look at what is actually there, and we ask the awkward questions early.
In writing, itemised, free. If something might add cost later we flag it now rather than at the end.
Same crew throughout. We cover your floors, keep the dust down and tidy up before we leave each day.
You point out anything you are not happy with and we fix it before the invoice, not after.
Deck crews travel throughout the Rio Grande Valley for these jobs.
Questions that come up once a deck project actually gets underway.
Describe the problem and we will tell you what it probably is. No obligation.